source: hybrid/branches/releng-9.0/nanobsd/files/etc/ipfw.sh@ 10179

#!/bin/sh -
# Based on /etc/rc.firewall
#
# Credits: Richard van Mansom, Rick van der Zwet


allowed2internet="80,443"
maxconnections="10"

RFC1918_nets="10.0.0.0/8,172.16.0.0/12,192.168.0.0/16"
WLNET='172.16.0.0/12'

# Suck in the configuration variables.
if [ -z "${source_rc_confs_defined}" ]; then
        if [ -r /etc/defaults/rc.conf ]; then
                . /etc/defaults/rc.conf
                source_rc_confs
        elif [ -r /etc/rc.conf ]; then
                . /etc/rc.conf
        fi
fi

setup_loopback () {
        ############
        # Only in rare cases do you want to change these rules
        #
        ${fwcmd} add 100 pass all from any to any via lo0
        ${fwcmd} add 200 deny all from any to 127.0.0.0/8
        ${fwcmd} add 300 deny ip from 127.0.0.0/8 to any
}

############
# Set quiet mode if requested
#
case ${firewall_quiet} in
[Yy][Ee][Ss])
        fwcmd="/sbin/ipfw -q"
        ;;
*)
        fwcmd="/sbin/ipfw"
        ;;
esac

###########
# Set Internal/External Interface
#
driver=`echo ${internalif} | sed 's/[0-9]*//g'`
seq=`echo ${internalif} | sed 's/[a-zA-Z]*//g'`

if [ ${seq} = 0 ]; then
  seq=`expr ${seq} \+ 1`
else
  seq=`expr ${seq} \- 1`
fi

externalif="$driver$seq"

# Get interface Addresses
externalip=`ifconfig $externalif | awk '/inet/ { print $2 }'`
internalip=`ifconfig $internalif | awk '/inet/ { print $2 }'`
############
# Flush out the list before we begin.
#
${fwcmd} -f flush

setup_loopback


############
# Block the hosters network (and maybe others)
for IP in ${firewall_block}
do
  ${fwcmd} add deny ip from any to ${IP} in via $internalif
done

############
# Statefull filewall in use
${fwcmd} add check-state

# Allow anything originating from me
${fwcmd} add allow ip from me to any keep-state


#############
# Outbound NAT setup
# WL Net -> Internet
${fwcmd} add nat 100 all from $WLNET to any out recv $internalif xmit $externalif
${fwcmd} add nat 100 all from any to $externalip in recv $externalif
${fwcmd} nat 100 config if $externalif

# Subnet Internet is allowed
${fwcmd} add allow tcp from $WLNET to any $allowed2internet in via $internalif setup limit src-addr $maxconnections


#############
# Internal Network -> WL Net
# Inbound NAT setup, to allow proxy device to be used gateway from Internal Network to WL
${fwcmd} add nat 200 all from $RFC1918_nets to $WLNET out recv $externalif xmit $internalif
${fwcmd} add nat 200 all from $WLNET to $internalip in recv $internalif
${fwcmd} nat 200 config if $internalif

# Allow all traffic inbound
${fwcmd} add allow all from $RFC1918_nets to $WLNET in recv $externalif keep-state


#############
## Services in use
## Allow on external interface
external_allow_tcp="ssh"
${fwcmd} add allow tcp from any to me $external_allow_tcp via $externalif setup keep-state

## Allow on internal interface
internal_allow_tcp="ssh,domain,3128"
internal_allow_udp="ntp,domain,snmp,12345"
${fwcmd} add allow udp from $WLNET to me ${internal_allow_udp} via $internalif keep-state
${fwcmd} add allow tcp from $WLNET to me ${internal_allow_tcp} via $internalif setup keep-state

# Basic ICMP managment traffic
${fwcmd} add allow icmp from any to me icmptype 8
${fwcmd} add allow icmp from me to any icmptype 3,4,11


#############
# Block anything else
${fwcmd} add 65000 deny log logamount 500 ip from any to any