wiki:SerialOutput

Version 1 (modified by ed, 8 years ago) ( diff )

--

Edgrouter at boot

Broadcast message from root@ubnt (ttyS0) (Wed Jun 1 10:35:33 2011):

The system is going down for reboot NOW! INIT: Switching to runlevel: 6 INIT: SenStopping routing services...zebra...done. Removing all Quagga Routes. Stopping EdgeOS router: rl-system. Asking all remaining processes to terminate...done. All processes ended within 2 seconds....done. Stopping enhanced syslogd: rsyslogd. Mounting root read-only...done. Mounting root dev read-only...done. Will now restart. Restarting system.

Looking for valid bootloader image.... Jumping to start of image at address 0xbfc80000

U-Boot 1.1.1 (UBNT Build ID: 4670715-gbd7e2d7) (Build time: May 27 2014 - 11:15:15)

BIST check passed. UBNT_E100 r1:1, r2:27, f:8/135, serial #: 802AA88E4E4F MPR 13-00290-27 Core clock: 500 MHz, DDR clock: 266 MHz (532 Mhz data rate) DRAM: 512 MB Clearing DRAM....... done Flash: 8 MB Net: octeth0, octeth1, octeth2

USB: (port 0) scanning bus for devices... 1 USB Devices found

scanning bus for storage devices...

Device 0: Vendor: Prod.: USB DISK 2.0 Rev: PMAP

Type: Removable Hard Disk Capacity: 3824.0 MB = 3.7 GB (7831552 x 512)

0

reading vmlinux.64 ........................................

8081560 bytes read argv[2]: coremask=0x3 argv[3]: root=/dev/sda2 argv[4]: rootdelay=15 argv[5]: rw argv[6]: rootsqimg=squashfs.img argv[7]: rootsqwdir=w argv[8]: mtdparts=phys_mapped_flash:512k(boot0),512k(boot1),64k@1024k(eeprom) ELF file is 64 bit Allocating memory for ELF segment: addr: 0xffffffff81100000 (adjusted to: 0x1100000), size 0x7f2a90 Allocated memory for ELF segment: addr: 0xffffffff81100000, size 0x7f2a90 Processing PHDR 0

Loading 79a980 bytes at ffffffff81100000 Clearing 58110 bytes at ffffffff8189a980

## Loading Linux kernel with entry point: 0xffffffff81105cd0 ... Bootloader: Done loading app on coremask: 0x3 Linux version 2.6.32.13-UBNT (ancheng@ubnt-builder2) (gcc version 4.3.3 (Cavium Networks Version: 2_0_0 build 99) ) #1 SMP Tue Jun 4 14:54:28 PDT 2013 CVMSEG size: 2 cache lines (256 bytes) Cavium Networks SDK-2.0 CPU revision is: 000d0601 (Cavium Octeon+) Checking for the multiply/shift bug... no. Checking for the daddiu bug... no. Determined physical RAM map:

memory: 0000000000034000 @ 000000000186c000 (usable after init) memory: 0000000006800000 @ 0000000001900000 (usable) memory: 0000000007c00000 @ 0000000008200000 (usable) memory: 000000000fc00000 @ 0000000410000000 (usable)

Wasting 350112 bytes for tracking 6252 unused pages Zone PFN ranges:

DMA32 0x0000186c -> 0x00100000 Normal 0x00100000 -> 0x0041fc00

Movable zone start PFN for each node early_node_map[4] active PFN ranges

0: 0x0000186c -> 0x000018a0 0: 0x00001900 -> 0x00008100 0: 0x00008200 -> 0x0000fe00 0: 0x00410000 -> 0x0041fc00

Cavium Hotplug: Available coremask 0x0 PERCPU: Embedded 10 pages/cpu @a8000000020b8000 s10624 r8192 d22144 u65536 pcpu-alloc: s10624 r8192 d22144 u65536 alloc=16*4096 pcpu-alloc: [0] 0 [0] 1 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 63895 Kernel command line: bootoctlinux $loadaddr coremask=0x3 root=/dev/sda2 rootdelay=15 rw rootsqimg=squashfs.img rootsqwdir=w mtdparts=phys_mapped_flash:512k(boot0),512k(boot1),64k@1024k(eeprom) console=ttyS0,115200 PID hash table entries: 1024 (order: 1, 8192 bytes) Dentry cache hash table entries: 32768 (order: 6, 262144 bytes) Inode-cache hash table entries: 16384 (order: 5, 131072 bytes) Primary instruction cache 32kB, virtually tagged, 4 way, 64 sets, linesize 128 bytes. Primary data cache 16kB, 64-way, 2 sets, linesize 128 bytes. Memory: 483444k/491728k available (3478k kernel code, 8064k reserved, 4118k data, 208k init, 0k highmem) Hierarchical RCU implementation. NR_IRQS:152 Calibrating delay loop (skipped) preset value.. 1000.00 BogoMIPS (lpj=5000000) Security Framework initialized Mount-cache hash table entries: 256 Checking for the daddi bug... no. SMP: Booting CPU01 (CoreId 1)... CPU revision is: 000d0601 (Cavium Octeon+) Brought up 2 CPUs NET: Registered protocol family 16 bio: create slab <bio-0> at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb Switching to clocksource OCTEON_CVMCOUNT NET: Registered protocol family 2 IP route cache hash table entries: 2048 (order: 2, 16384 bytes) TCP established hash table entries: 8192 (order: 5, 131072 bytes) TCP bind hash table entries: 8192 (order: 5, 131072 bytes) TCP: Hash tables configured (established 8192 bind 8192) TCP reno registered NET: Registered protocol family 1 /proc/octeon_perf: Octeon performace counter interface loaded octeon_wdt: Initial granularity 5 Sec. squashfs: version 4.0 (2009/01/31) Phillip Lougher Registering unionfs 2.5.11 (for 2.6.32.55) msgmni has been set to 944 alg: No test for stdrng (krng) io scheduler noop registered io scheduler cfq registered (default) Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x1180000000800 (irq = 58) is a OCTEON console [ttyS0] enabled loop: module loaded ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver OcteonUSB: Detected 1 ports OcteonUSB OcteonUSB.0: Octeon Host Controller OcteonUSB OcteonUSB.0: new USB bus registered, assigned bus number 1 OcteonUSB OcteonUSB.0: irq 80, io mem 0x00000000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected OcteonUSB: Registered HCD for port 0 on irq 80 Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usbcore: registered new interface driver libusual Probing USB hub... hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected TCP cubic registered NET: Registered protocol family 17 NET: Registered protocol family 15 L2 lock: TLB refill 256 bytes L2 lock: General exception 128 bytes L2 lock: low-level interrupt 128 bytes L2 lock: interrupt 640 bytes L2 lock: memcpy 1152 bytes Bootbus flash: Setting flash for 8MB flash at 0x1f400000 phys_mapped_flash: Found 1 x16 devices at 0x0 in 8-bit bank

Amd/Fujitsu Extended Query Table at 0x0040

phys_mapped_flash: Swapping erase regions for broken CFI table. number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. 3 cmdlinepart partitions found on MTD device phys_mapped_flash Creating 3 MTD partitions on "phys_mapped_flash": 0x000000000000-0x000000080000 : "boot0" 0x000000080000-0x000000100000 : "boot1" 0x000000100000-0x000000110000 : "eeprom" Waiting 15sec before mounting root device... hub 1-0:1.0: activate --> -22 usb 1-1: new high speed USB device using OcteonUSB and address 2 usb 1-1: configuration #1 chosen from 1 choice scsi0 : SCSI emulation for USB Mass Storage devices scsi 0:0:0:0: Direct-Access USB DISK 2.0 PMAP PQ: 0 ANSI: 6 sd 0:0:0:0: [sda] 7831552 512-byte logical blocks: (4.00 GB/3.73 GiB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Assuming drive cache: write through

sda: sda1 sda2

sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Attached SCSI removable disk kjournald starting. Commit interval 5 seconds EXT3 FS on sda2, internal journal EXT3-fs: mounted filesystem with writeback data mode. VFS: Mounted root (unionfs filesystem) on device 0:12. Freeing unused kernel memory: 208k freed Algorithmics/MIPS FPU Emulator v1.5 INIT: version 2.88 booting INIT: Entering runlevel: 2 Starting routing daemon: rib. Starting EdgeOS router: migrate rl-system configure.

Welcome to EdgeOS ubnt ttyS0

By logging in, accessing, or using the Ubiquiti product, you acknowledge that you have read and understood the Ubiquiti License Agreement (available in the Web UI at, by default, http://192.168.1.1) and agree to be bound by its terms.

ubnt login:

Note: See TracWiki for help on using the wiki.