= Ubiquiti EdgeRouter node =

== Hardware ==
Ubiquiti Edgerouter POE [[BR]]
Air Gateway [[BR]]
Air Gateway Pro [[BR]]
Air Gateway LR [[BR]]

=== Edgerouter POE (ERPoe-5)===
'''Specifications'''
{{{
    Dual Core 500 MHz Processor (Cavium Octeon+)
    512 MB DDR2 RAM Memory
    2 GB On-Board Flash Storage
    5 x Gigabit Routing Ports (POE 24V or 48V)
}}}
All ports can be used for routing and support 10/100/1000 Mbps connections with configurable PoE settings. [[BR]]
eth2, eth3, and eth4 can be configured for switching. [[BR]][[BR]]



RJ45 serial console port for Command Line Interface (CLI) management. Use a RJ45-to-DB9 serial console cable [[BR]]
to connect  the Console port to your computer. [[BR]]


{{{
$eddie@MacBook-Pro:~>sudo cu -l /dev/tty.usbserial-FTF6RNL3 -s 115200
}}}

The output with the original usb stick removed from the board is:


{{{
Looking for valid bootloader image....
Jumping to start of image at address 0xbfc80000


U-Boot 1.1.1 (UBNT Build ID: 4670715-gbd7e2d7) (Build time: May 27 2014 - 11:15:15)

BIST check passed.
UBNT_E100 r1:1, r2:27, f:8/135, serial #: 802AA88E4E4F
MPR 13-00290-27
Core clock: 500 MHz, DDR clock: 266 MHz (532 Mhz data rate)
DRAM:  512 MB
Clearing DRAM....... done
Flash:  8 MB
Net:   octeth0, octeth1, octeth2

USB:   (port 0) No USB devices found.
 0 
** Partition 1 not valid on device 0 **

** Unable to use usb 0:1 for fatload **
argv[2]: coremask=0x3
argv[3]: root=/dev/sda2
argv[4]: rootdelay=15
argv[5]: rw
argv[6]: rootsqimg=squashfs.img
argv[7]: rootsqwdir=w
argv[8]: mtdparts=phys_mapped_flash:512k(boot0),512k(boot1),64k@1024k(eeprom)
## No elf image at address 0x09f00000
Octeon ubnt_e100# 

}}}




== Reference ==
[http://www.daemonology.net/blog/2016-01-10-FreeBSD-EdgeRouter-Lite.html][[BR]]
[http://rtfm.net/FreeBSD/ERL/][[BR]]
[http://www.tedunangst.com/flak/post/OpenBSD-on-ERL][[BR]]
[http://ftp.openbsd.org/pub/OpenBSD/snapshots/octeon/INSTALL.octeon]